OPERATION Check Coolant Level, Add Coolant Do not open the radiator cap unless necessary. Wait for the engine to cool down before checking the coolant in the sub-tank. Immediately after the engine is stopped, the coolant is at a high temperature and the radiator is under high internal pressure. If the cap is removed to check the coolant level in this condition, there is a hazard of burns. Wait for the temperature to go down, then turn the cap slowly to release the pressure before removing it. 1. Open the door at the rear left of the machine, and check if the coolant in sub-tank (1) (shown in the diagram on the right) is between the FULL and LOW marks.
If the coolant level is low, add coolant to the FULL level through the filler port of sub-tank (1). 2. After adding coolant, tighten the cap securely. 3. If the sub-tank (1) is empty, there is probably leakage of coolant. After inspecting, repair any problem immediately. If there is no problem, check the coolant level in the radiator. If the coolant level is low, add coolant to the radiator, then fill the sub-tank (1). 4. If the inside of sub-tank (1) is dirty and the water level cannot be seen, use the procedure in “Clean Inside of Cooling System” on page 3-29. PC200LC-8 2-119