Komatsu — Checks Before Starting

OPERATION Check Oil Level in Engine Oil Pan, Add Oil Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. 1. Open the engine hood on the machine. 2. Remove dipstick (G), and wipe the oil off with a cloth. 3. Fully insert dipstick (G) into filler pipe (F), then remove it. 4. The oil level should be between the H and L marks on dipstick (G). If the oil level is below the L mark, add oil through oil filler (F). 5. If the oil is above the H line, open drain valve (P) at the bottom of the engine oil pan, drain the excess engine oil, then check the oil level again. 6.

If oil level is correct, securely tighten the oil filler cap and close the engine hood. Remark When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, move it to a horizontal position before checking. 2-120 PC200LC-8