OPERATION Adjustment Seat Adjustment When adjusting the position of the operator's seat, always set lock lever (1) to LOCK position (L) to prevent the machine or work equipment from moving if there is accidental contact with the control levers. Always adjust the operator's seat before starting each operation or when the operators change shift. Adjust the operator's seat so control levers and switches can be operated freely and easily with the operator's back against the backrest. (A) Fore-and-aft adjustment Pull lever (1) up, set the seat to the desired position, then release the lever. Fore-and-aft adjustment: . . . . . . . . .
160 mm (6.3 in) (16 stages) (B) Adjusting reclining Remark The operator's seat can be reclined to a large angle when the seat is completely pushed forward, but the reclining angle is reduced when the seat is moved backward. So return the seat to its upright position before moving the seat to the rear. Pull up lever (2) and set the backrest to a position that is comfortable for operation, then release the lever. Sit with your back against the seat backrest when adjusting. If your back is not against the backrest, the backrest may suddenly move forward. (C) Adjusting seat tilt Forward tilt Push lever (3) down to adjust angle of the front of seat.
(four stages) To raise the angle at front of the seat, keep the lever pushed down and apply your weight to the rear of seat. To lower the angle at front of the seat, keep the lever pushed down and apply your weight to the front of seat. Rear tilt Pull lever (4) up to adjust angle of the rear of seat. (four stages) To raise the angle at rear of the seat, keep lever (3) pulled up, and stand up slightly to remove your weight from the seat. To lower the angle at rear of the seat, keep lever (3) pulled up, and apply your weight to the seat. Amount of tilt: . . . . . . . . . . . . . . . . . . . . . . . . . . .Up 13°, down 13° 2-124 PC200LC-8