OPERATION 2. Set fuel control dial (2) to the low idling (MIN) position. 3. Turn the key in starting switch (3) to ON position (B). If the ambient temperature is low, the preheating monitor lights up and automatic preheating is carried out. Keep the key in starting switch (3) at the ON position until the preheating monitor goes out. The time that the preheating monitor stays lit depends on the ambient temperature as shown in the table on the right. 4. If the preheating monitor does not light up, or it lights up and then goes out to inform that the engine preheating has been completed, turn the key in starting switch (3) to the START position (C) and start the engine.
Remark If the ambient temperature is low, the engine may not start even when the key in the starting switch (3) is kept at the START position for 20 seconds. If this happens, wait for at least two minutes, then start again from the beginning. 5. After the engine starts, release the key in starting switch (3). The key will automatically return to the ON position (B). Remark When the engine is started, depending on the ambient temperature or the condition of the battery, the battery voltage may suddenly drop. If this happens, the display on the machine monitor will momentarily disappear, but this does not indicate any abnormality.
PC200LC-8 2-135 Ambient temperature Lighting time -4 °C to -15 °C 5 seconds to 30 seconds -15 °C or less 30 seconds