Komatsu — Hydraulic System Warm-Up

OPERATION Remark When the work equipment is retracted, take care that it does not interfere with the machine body or ground. 6. Move right work equipment control lever (5) slowly in the L.H. direction to pull in the bucket (D). Operate the lever to the end of its travel and hold it in position for 30 seconds. 7. Move right work equipment control lever (5) slowly in the R.H. direction to push out the bucket (C). Operate the lever to the end of its travel and hold it in position for 30 seconds. 8. Next, move left work equipment control lever (6) slowly in the machine rear direction to pull in the arm (B). Operate the lever to the end of its travel and hold it in position for 30 seconds. 9.

Move left work equipment control lever (6) slowly in the machine forward direction to push out the arm (A). Operate the lever to the end of its travel and hold it in position for 30 seconds. 10. Repeat the operation in Steps 6 to 9 for five minutes. 11. Check that hydraulic oil temperature monitor (7) indicates that the temperature, is within operating range (blue background). If it is not, repeat Steps 6 to 10 until the blue background is displayed. (A) Display when temperature is within operating range: Monitor background (C) is blue (B) Display when temperature is low: Monitor background (C) is white 12.

Check that engine coolant temperature monitor (1) indicates that the temperature is within operating range (blue background). (A) Display when temperature is within operating range: Monitor background (C) is blue (B) Display when temperature is low: Monitor background (C) is white If it displays low temperature, carry out additional warm-up of the engine until engine coolant temperature monitor (1) displays the blue background. For details of the procedure, See “Engine Warm Up” on page 2-139. 2-144 PC200LC-8