OPERATION 13. Check that the hydraulic oil temperature monitor and engine coolant temperature monitor indicate a working range temperature, then check that all the gauges and caution monitors on the machine monitor are in the following status. Radiator coolant level monitor (8): OFF Charge level monitor (9): OFF Engine oil pressure monitor (10): ON Engine oil level monitor (11): OFF Air cleaner clogging monitor (12): OFF Water separator monitor (13): OFF Engine pre-heating monitor (14): OFF Engine coolant temperature gauge (15): Indicator in green range Engine coolant temperature monitor (1): Displays correct temperature Hydraulic oil temperature gauge (16):
Indicator in green range Hydraulic oil temperature monitor (7): Displays correct temperature Fuel gauge (17): Indicator in green range Fuel level monitor (18): Displays appropriate level 14. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor. In cold temperatures (ambient temperature below 0°C (32°F)), even when the hydraulic oil temperature monitor displays a blue background, carry out additional Step 15 to warm up all the hydraulic equipment. 15.
Turn fuel control dial (4) to the full speed (MAX) position, repeat Steps 6 to 9 for three to five minutes, then check again that the hydraulic oil temperature monitor is displaying correct temperature. If it is not, repeat Steps 6 to 9 for three to five minutes until hydraulic oil temperature monitor (7) displays correct temperature. (A) Display when temperature is within operating range: Monitor background (C) is blue. (B) Display when temperature is low: Monitor background (C) is white. PC200LC-8 2-145