OPERATION For both normal temperatures and cold temperatures, carry out the following operation. 16. Check that fuel control dial (4) is at a point midway between low idling (MIN) and full speed (MAX). If it is not at the midway position, set it to the midway position and run the engine at a mid-range speed before operating. 17. Before starting operations, repeat the following operations slowly three to five times to circulate warm oil through the control circuits.
Boom operation RAISE (E) LOWER (F) Arm operation IN (B) OUT (A) Bucket operation CURL (D) DUMP (C) When carrying out swing operations, release swing lock switch (2), check that swing lock monitor (19) goes out, then operate the swing. Swing operation Left (G) Right (H) Travel (Lo) operation FORWARD (A) REVERSE (B) 2-146 PC200LC-8