Komatsu — Replacement

OPERATION Remark When installing the bucket, for arm pin portion (A), fit O-ring (3) to bucket (4) in the position shown in the diagram on the right. After inserting the pin, fit it in the standard groove. For link pin portion (B), install the bucket with O-ring (3) fitted in the standard groove. 4. Install the stopper bolts and nuts for each pin, then grease the pin. Remark Lubricate with grease thoroughly until the grease comes out from the end face. When replacing the bucket, replace the dust seal if it has been damaged. If a damaged seal is used without being replaced, sand and dirt may enter the pin portion and cause abnormal wear of the pin. 2-172 PC200LC-8