Komatsu — Inversion

OPERATION Inversion 1. Place the bucket in contact with a flat surface. Remark When removing the pins, place the bucket so that it is in light contact with the ground. If the bucket is lowered strongly to the ground, the resistance will be increased and it will be difficult to remove the pins. Remark After removing the pins, make sure that mud or sand does not get on them. Dust seals are fitted at both ends of the bushings, be careful not to damage them. 2. Remove the double nut on the stopper bolt for arm pin (A) and link pin (B), remove the bolt, pull out arm pin (A) and link pin (B), and then remove the bucket. 3. Turn the removed bucket.

After turning the bucket, align the arm (5) with link mounting hole (1), then align the link with arm mounting hole (2) and install. 4. Align the arm with holes (1) of the replacement bucket and the link with holes (2), then insert grease-coated pins (A) and (B) into hole (1) and hole (2) respectively. Remark When reversing, do not install an O-ring. Keep the O-ring in a safe place until using it next. 5. Install the stopper bolts and nuts for each pin, then grease the pin. PC200LC-8 2-173