OPERATION 6. If the machine is equipped with work equipment, set the work equipment at the front, and travel forward to load it; if it has no work equipment, travel in reverse to load it. Follow instructions and signals of a conductor particularly when traveling in reverse. 7. Before moving onto the ramps, make sure that the machine is positioned in a straight line with the ramps and that the centerline of the machine matches that of the trailer. Align the direction of travel with the ramps and travel slowly. Lower the work equipment as far as possible without causing interference. When on the ramps, operate only the travel lever. Do not operate any other lever. 8.
When loading or unloading a machine with the work equipment installed, at the point where the tracks are on both the ramps and the ground surface, turn the swing lock switch OFF, then swing the upper structure slowly 180°. After doing that, drive slowly in reverse and load the machine onto the trailer. 9. Turn the swing lock switch ON to lock the swing lock. When the swing lock switch is turned to the ON position, pilot monitor display (9) lights up. (a): ON position (b): OFF position 2-180 PC200LC-8