OPERATION When loading or unloading, always use ramps or a platform. Proceed as follows: Loading 1. Load and unload on firm level ground only. Maintain a safe distance from the edge of a road. 2. Apply the trailer brakes securely, then put blocks (1) under the tires to prevent the trailer from moving. Set left and right ramps (2) parallel to each other and equally spaced to the left and right of center (3) of the trailer. Make angle of installation (4) a maximum of 15°. If the ramps bend a large amount under the weight of the machine, put blocks under the ramps to prevent them from bending. 3. Turn the travel speed selector switch to low speed travel (Lo lamp lights up).
Press travel speed selector switch (5) to switch the travel speed. The travel speed (Lo, Mi, Hi) is displayed on pilot monitor display portion (6). 4. Turn auto-deceleration switch (7) OFF and set the fuel control dial to run the engine at low speed. Each time auto-deceleration switch (7) is pressed, it switches OFF ON OFF. When auto-deceleration switch (7) is turned OFF, pilot monitor display (8) goes out. 5. Turn the swing lock switch ON to apply the swing lock. When the swing lock switch is turned to the ON position, pilot monitor display (9) lights up. (a): ON position (b): OFF position PC200LC-8 2-179