Komatsu — Loading and Unloading with Trailer

OPERATION Loading and Unloading with Trailer Always obey the following when loading or unloading the machine from a trailer. Select firm, level ground when loading or unloading the machine. Maintain a safe distance from the edge of the road. Always turn the auto-deceleration switch OFF (cancel). If the auto-deceleration switch is left ON, the machine may suddenly start moving. Always set the travel speed switch to low speed (Lo), run the engine at low idling, and operate the machine slowly when loading or unloading. In cold areas, carry out the warming-up operation thoroughly and make sure that the engine speed is stable before carrying out the loading or unloading operation.

Never correct your steering on the ramps. There is danger that the machine may tip over. If necessary, drive off the ramps or back on to the trailer and correct the direction. It is dangerous to use the work equipment for loading and unloading operations. Always use ramps. When on the ramps, do not operate any lever except the travel lever. The center of gravity of the machine will change suddenly at the joint between the ramps and the trailer, and there is danger of the machine losing its balance. Travel slowly over this point. If it is necessary to swing the work equipment on the trailer platform, the footing is unstable, so be extremely careful that the machine does not tip over.

If the work equipment is installed to the machine, pull the work equipment in, and operate slowly to prevent the machine from losing its balance. Position a flagman to give guidance to prevent the machine from coming off the ramps and to ensure safety in the operation. Always observe the following regarding the ramps and trailer platform. Use ramps with ample width, length, thickness, and strength and install them at a maximum slope of 15°. When using piled soil, compact the piled soil fully to prevent the slope face from collapsing. Clean the machine tracks and ramps before starting in order to prevent the machine from slipping on the ramps.

There is danger of the machine slipping if there is water, snow, grease, oil, or ice on the ramp surface. 2-178 PC200LC-8