Komatsu — Unloading

OPERATION Unloading 1. Load and unload on firm level ground only. Maintain a safe distance from the edge of a road. 2. Apply the trailer brakes securely, then put blocks (1) under the tires to prevent the trailer from moving. Set left and right ramps (2) parallel to each other and equally spaced to the left and right of center (3) of the trailer. Make angle of installation (4) a maximum of 15°. If the ramps bend a large amount under the weight of the machine, put blocks under the ramps to prevent them from bending. 3. Remove the chains and wire ropes fastening the machine. 4. Start the engine. Warm the engine up. 5. Set the lock lever to FREE position (F). 6.

Turn the travel speed selector switch to low speed travel (Lo lamp lights up). Press travel speed selector switch (5) to switch the travel speed. The travel speed (Lo, Mi, Hi) is displayed on pilot monitor display portion (6). 7. Turn auto-deceleration switch (7) OFF and operate the fuel control dial to set the engine speed to low idling. Each time auto-deceleration switch (7) is pressed, it switches OFF ON OFF in turn. When auto-deceleration switch (7) is turned OFF, pilot monitor display (8) goes out. PC200LC-8 2-185