OPERATION 8. Raise the work equipment, pull in the arm under the boom, then move the machine slowly. 9. When the machine is horizontal on top of the rear wheels of the trailer, stop the machine. Remark When unloading the machine, always keep the arm and boom at an angle of 90° - 110°. If the machine is unloaded with the arm pulled in, it will cause damage to the machine. When moving onto the ramps, do not thrust the bucket into the ground. This will cause damage to the hydraulic cylinders. 10. When moving from the rear of the trailer on to the ramps, set the angle of the arm and boom to 90° to 110°, lower the bucket to the ground, then move the machine slowly. 11.
When moving down the ramps, operate the boom and arm slowly to lower the machine carefully until it is completely off the ramps. 2-186 PC200LC-8