OPERATION COLD WEATHER OPERATION Cold Weather Operation Information If the temperature becomes low, it becomes difficult to start the engine, and the coolant may freeze, so do as follows. Fuel and Lubricants Remark Be aware that when shipping new machines during winter months that changing engine oil to a winter oil, from the factory filled oil, is necessary. (Factory fill is 15W-40) Winter oils such as 0W-30, 5W-40 or 10W-30 viscosity grade should be used. Changing oil to a lower viscosity in extremely cold temperatures will prevent error code “B@BAZG: Engine Oil Pressure, Low - Error”. Change to fuel and oil with low viscosity for all components.
For details of the specified viscosity, See “RECOMMENDED FUEL, COOLANT, AND LUBRICANT” on page 3-9. Cooling System Coolant Antifreeze is toxic. Be careful not to get it into your eyes or on your skin. If it should get into your eyes or on your skin, wash it off with large amounts of fresh water and see a doctor at once. When changing the coolant or when handling coolant containing antifreeze that has been drained when repairing the radiator, please contact your Komatsu distributor or request a specialist company to carry out the operation. Antifreeze is toxic. Do not let it flow into drainage ditches or spray it onto the ground surface. Antifreeze is flammable. Do not bring any flame close.
Do not smoke when handling antifreeze. Remark Use Komatsu Supercoolant wherever available, or use permanent type antifreeze coolant. Never use methanol, ethanol, or propanol-based antifreeze. Do not use any water leakage prevention agent, either alone, or in combination with antifreeze. Do not mix one brand of antifreeze with a different brand. When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. For details of the antifreeze mixture when changing the coolant, See “Clean Inside of Cooling System” on page 3-29. PC200LC-8 2-191