Komatsu — MAINTENANCE INFORMATION

MAINTENANCE MAINTENANCE INFORMATION Do not perform any inspection and maintenance operation that is not found in this manual. Service Meter Reading Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. Komatsu Genuine Replacement Parts Use Komatsu genuine parts specified in the Parts Book as replacement parts. Komatsu Genuine Lubricants Use Komatsu genuine oils and grease. Choose oils and grease with proper viscosities specified for ambient temperature. Windshield Washer Fluid Use automobile window washer fluid, and be careful not to let any dirt get into it. Fresh and Clean Lubricants Use clean oil and grease.

Also, keep the containers of the oil and grease clean. Keep foreign materials away from oil and grease. Check Drained Oil and Used Filter After oil is changed or filters are replaced, check the old oil and filters for metal particles and foreign materials. If large quantity of metal particles or foreign materials are found, always report to the person in charge, and carry out suitable action. Fuel Strainer If your machine is equipped with a fuel strainer, do not remove it while fueling. Welding Instructions Turn off the engine starting switch. Do not apply more than 200 V continuously. Connect grounding cable within 1 m (3.3 ft) of the area to be welded.

If grounding cable is connected near instruments, connectors, etc., the instruments may malfunction. If a seal or bearing happens to come between the part being welded and grounding point, change the grounding point to avoid such parts. Do not use the area around the work equipment pins or the hydraulic cylinders as the grounding point. Do not Drop Things Inside Machine When opening inspection windows or the oil filler port of the tank to carry out inspection, be careful not to drop nuts, bolts, or tools inside the machine. If such things are dropped inside the machine, it may cause damage and/or malfunction of the machine, and will lead to failure.

If you drop anything inside the machine, always remove it immediately. Do not put unnecessary things in your pockets. Carry only things which are necessary for inspection. Dusty Jobsite When working at dusty worksites, do as follows: Clean the radiator core, oil cooler core, aftercooler core, fuel cooler core, and condenser core frequently to avoid clogging. Replace the fuel filter more frequently. Clean electrical components, especially the starting motor and alternator, to avoid accumulation of dust. When checking and replacing the oil or filters, move the machine to a place where there is no dust and take care to prevent dust from entering the system.

Avoid Mixing Lubricants If a different brand or grade of oil has to be added, drain the old oil and replace all the oil with the new brand or grade of oil. Never mix different brand or grade of oil. 3-2 PC200LC-8