Locking the Inspection Covers MAINTENANCE Lock inspection cover securely into position with the lock bar. If inspection or maintenance is performed with inspection cover not locked in position, there is a danger that it may be suddenly blowing shut by the wind and cause injury to the worker. Hydraulic System - Air Bleeding When hydraulic equipment has been repaired or replaced, or the hydraulic piping has been removed and installed again, the air must be bled from the circuit. For details, See “Bleeding Air from Hydraulic System” on page 3-49.
Hydraulic Hose Installation When removing parts at locations where there are O-rings or gasket seals, clean the mounting surface, and replace with new parts. When doing this, be careful not to forget to assemble the O-rings and gaskets. When installing the hoses, do not twist them or bend them sharply. If they are installed so, their service life will be extremely shortened and they may be damaged. Checks After Inspection and Maintenance Works If you forget to perform the checks after inspection and maintenance, unexpected problems may occur, and this may lead to serious injury or property damage. Always do the following:
Checks after operation (with engine stopped) Have any inspection and maintenance points been forgotten? Have all inspection and maintenance items been performed correctly? Have any tools or parts been dropped inside the machine? It is particularly dangerous if parts are dropped inside the machine and get caught in the lever linkage mechanism. Are there any leakage of coolant or oil? Have all nuts and bolts been tightened? Checks when operating engine For details of the checks when operating the engine, See “Two Workers for Maintenance When Engine Is Running” on page 1-36 and pay careful attention to safety. Are the inspection and maintenance items working properly?
Is there any leakage of fuel or oil when the engine speed is raised? Close engine hood securely When closing the engine hood after inspection or maintenance, make sure that the catch is securely locked. Hold the grip of the engine hood and raise it slightly. If it does not open, the catch is locked. If the engine hood catch is not locked, there is danger that the engine hood may open. PC200LC-8 3-3