Komatsu — Torque for O-ring Boss Piping Joints

MAINTENANCE Torque for Flared Nuts Use these torques for flared part of nut. Torque for O-ring Boss Piping Joints Unless there are special instructions, tighten the O-ring boss piping joints to the torque below. 3-14 PC200LC-8 Thread diameter Width across flat Tightening torque mm mm N•m lbf ft 14 19 24.5 ± 4.9 18.0 ± 3.6 18 24 49 ± 19.6 36.1 ± 14.4 22 27 78.5 ± 19.6 57.8 ± 14.4 24 32 137.3 ± 29.4 101.2 ± 21.6 30 36 176.5 ± 29.4 130.1 ± 21.6 33 41 196.1 ± 49 144.6 ± 36.1 36 46 245.2 ± 49 180.8 ± 36.1 42 55 294.2 ± 49 216.9 ± 36.1 Norminal No. Thread diameter Width across flat Tightening torque (N•m {lbf ft}) mm mm Range Target 02 14 Varies depending on type of connector.

35 - 63 {25.81 - 46.46} 44 {32.45} 03, 04 20 84 - 132 {61.95 - 97.35} 103 {75.96} 05, 06 24 128 - 186 {94.40 - 137.18} 157 {115.79} 10, 12 33 363 - 480 {267.73 - 354.02} 422 {311.25} 14 42 746 - 1010 {550.22 - 744.93} 883 {651.26}