Komatsu — Check and Adjust Track Tension

MAINTENANCE Check and Adjust Track Tension For details on starting the engine and operating the work equipment, See “Before Starting Engine” on page 2-115, “STARTING ENGINE” on page 2-134, “AFTER STARTING ENGINE” on page 2-138, and “WORK EQUIPMENT CON- TROLS AND OPERATIONS” on page 2-158. Wear on pins and bushings of the undercarriage will vary with working conditions and type of soil, so inspect the track tension every now and then in order to maintain the standard tension. For carrying out inspection and adjustment of track shoes, park the machine on the flat and solid ground. Checking 1.

Run the engine at low idle, then move the machine forward for a distance equal to the track length on ground, and slowly stop the machine. 2. Put on the track shoe a straight wooden bar (3) which stretches from idler (1) to upper carrier roller (2). 3. Measure the maximum deflection between bottom surface of the wooden bar and top surface of the track shoe. Deflection “a” should be 10 - 30 mm (0.4 - 1.2 in). If the track tension is not at the standard value, adjust it in the following manner. Adjustment • Grease inside the adjusting mechanism is under high pressure. Grease coming from plug (1) under pressure can penetrate the body, causing injury or death.

For this reason, do not loosen plug (1) more than one turn. • Do not loosen any part other than plug (1). Furthermore, do not bring your face in front of the plug (1). • If track tension is not relieved by this procedure, contact your Komatsu distributor for repairs. Increasing Track Tension Prepare a grease pump. 1. Pump in grease through grease fitting (2) with a grease pump. (Grease fitting (2) forms one part with plug (1).) 2. To check if the tension is correct, run the engine at low idle, move the machine slowly forward (by an amount equal to the length of track on ground), then stop the machine. 3. Check the track tension again, and if the tension is not correct, adjust it again.

3-34 PC200LC-8