MAINTENANCE 2. If the electrolyte level is below the midway point between the UPPER LEVEL and LOWER LEVEL lines, remove cap (2) and add distilled water to the UPPER LEVEL line. 3. After adding distilled water, tighten cap (2) securely. Remark If distilled water is added to above the UPPER LEVEL line, use a syringe to lower the level to the UPPER LEVEL line. Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker.
When it is Impossible to Check Electrolyte Level from Side of Battery If it is impossible to check the electrolyte level from the side of the battery, or there is no display of the UPPER LEVEL line on the side of the battery, check as follows. 1. Remove cap (2) at the top of the battery, look through the water filler port (3), and check the electrolyte surface. If the electrolyte does not reach the sleeve (4), add distilled water so that the level reaches the bottom of the sleeve (UPPER LEVEL line) without fail. (A) Suitable level: Electrolyte level is up to bottom of sleeve, so surface tension causes electrolyte surface to bulge and poles appear bent. (B) Low:
Electrolyte level is not up to bottom of sleeve, so poles appear straight and not bent. 2. After adding distilled water, tighten cap (2) securely. Remark If distilled water is added to above the bottom of the sleeve, use a syringe to lower the level to the bottom of the sleeve. Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker. When it is Possible to Use Indicator to Check Electrolyte Level If it is possible to use an indicator to check the electrolyte level, follow the instructions given. PC200LC-8 3-55