MAINTENANCE Check Air Conditioner Compressor Belt Tension, Adjust Checking Press the belt with a finger force of approximately 60 N (6.2 kgf) at a point midway between drive pulley (1) and compressor pulley (2). Deflection (A) . . . . . . . . . . . . . . 6.3 to 8.7 mm (0.248 to 0.343 in). Adjustment 1. Loosen bolts (1) and (2). Compressor (3) is installed to bracket (4), so when bolts (1) and (2) are loosened, it becomes possible to move bracket (4) with the mounting position of bolt (2) as the fulcrum. 2. Move compressor (3) to adjust. 3. When the position of the compressor is determined, tighten bolts (1) and (2) to hold it in position.
Remark • Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. • In case any of the following occurs, ask the Komatsu distributor in your territory to replace the belts with new ones. • The fan belt has elongated, leaving little allowance for adjustment. • A cut or crack is found on the belt. • Slipping or creaking sound is heard coming from the belt. • When the new V-belt is set, readjust it after one hour of operation. 3-56 PC200LC-8