Komatsu — Replace Engine Oil Filter Cartridge

MAINTENANCE Change Oil in Engine Oil Pan Replace Engine Oil Filter Cartridge Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. Refill capacity of oil pan: . . . . . . . . . . . . .23.1 liters (6.10 US gal) Filter wrench 1. Remove the inspection cover of the undercover directly under drain plug (P) under the machine, then place a container to catch the oil. 2. To prevent getting oil on yourself, lower the lever of drain valve (P) slowly, drain the oil, then raise the lever to close the valve. 3.

Open the cover at the rear right, then use a filter wrench to turn filter cartridge (1) to the left to remove it. 4. Clean filter holder (2), fill the new filter cartridge with clean engine oil, coat the thread and packing surface of the new filter cartridge with clean engine oil (or coat it thinly with grease), then install it to the filter holder. Remark Check that there is no old packing stuck to filter holder (2). If there is any old packing stuck to the filter, it will cause leakage of oil. 5. When installing, tighten until the packing surface contacts the seal surface of filter holder (2), then tighten it a further 3/4 to 1 turn. 3-60 PC200LC-8