Komatsu — Replace Fuel Pre-Filter Cartridge

MAINTENANCE Replace Fuel Pre-Filter Cartridge • After the engine has been operated, all parts are at high temperature, so do not replace the filter immediately. Wait for all parts to cool down before starting the operation. • High pressure is generated inside the engine fuel piping system when the engine is running. • When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before replacing the filter. • Do not bring any fire or flame close. Remark • Genuine Komatsu fuel filter cartridges use a special filter that has highly efficient filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part.

• The common rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Always avoid using substitute parts. • When carrying out inspection or maintenance of the fuel system, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. Prepare a container to catch drain fuel. Prepare a filter wrench 1. Turn the valve (1) at the bottom of the fuel tank to the CLOSE position (S). 2. Open the cover on the right side of the machine. 3.

Set the container to catch the fuel under the pre-filter cartridge. 4. Loosen drain valve (2), then drain all the water and sediment in the transparent cap (3) and also the fuel accumulated in filter cartridge (4). 5. Remove connector (5). Wrap the removed connector in a vinyl bag to prevent water from getting on it. 6. Using a filter wrench, turn transparent cap (3) to the left to remove it. (This cap is used again.) 7. Using a filter wrench, turn cartridge (4) to the left to remove it. 8. Install transparent cap (3) to the bottom of the new filter cartridge. (When doing this, always replace O-ring (6).) 9.

When installing, apply oil to the packing surface and bring the packing surface into contact with the seal surface of filter cartridge (4) and then tighten it further by 1/4 - 1/2 turns. If the transparent cap is tightened too much, the O-ring will be damaged and this will cause leakage of fuel; if it is not tightened enough, fuel will leak through the gap at the O-ring. To prevent these problems, always tighten securely to the fixed tightening angle. 3-62 PC200LC-8