MAINTENANCE 10. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. Remark • When adding fuel, do not remove cap (B). Always add fuel from the eight small holes (A) on the dirty side. • After adding fuel, remove cap (B) and install the fuel filter. • Always fill with clean fuel. Be careful not to let any dirt or dust get into the fuel. In particular, center portion is the clean side, so do not remove cap (B) when adding fuel. Be careful not to let dirt or dust get into center portion on the clean side. 11.
When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten the correct amount. When tightening with a filter wrench, be extremely careful not to dent or damage the filter. 12. Check that the drain valve (2) is tightened securely. 13. Remove the vinyl bag covering connector (5), then connect connector (5).
Remark • If water gets on the connector (5), the sensor may malfunction and the water separator monitor may light up. When removing connector (5), be extremely careful not to let water get on the connector. • If water gets on connector (5), dry it completely before connecting it. 14. Turn the valve (1) at the bottom of the fuel tank to the OPEN position (O). 15. After completing the replacement of filter cartridge (4), bleed the air. Bleed the air as follows: 16. Fill the fuel tank with fuel (to the position where the float is at the highest position). 17. Loosen the knob of feed pump (7), pull it out, then pump it in and out until the movement becomes heavy.
Remark It is not necessary to remove the plug at the top of the fuel pre-filter and fuel main filter. After the engine runs out of fuel, use the same procedure to operate feed pump (7) and bleed the air. 18. After finishing bleeding the air, push in the knob of feed pump (7) and tighten it. 19. After replacing the filter cartridge, start the engine and run it at low idling for 10 minutes. Check for leakage of oil from the filter seal surface and transparent cap mounting. If any oil is leaking, check the tightening of the filter cartridge.
If there is still oil leakage, repeat Steps 1 - 7 to remove the filter cartridge, and if any damage or embedded foreign material in the packing surface is found, replace it with a new cartridge and repeat Steps 8 - 19 to install it. Remark Sometimes some air is still left inside water separator (3) after air bleeding, but the engine can be started by operating feed pump (7) until its motion gets hard. The remaining air is naturally bled when the water separator is left as it is for some time after the engine comes to a stop. PC200LC-8 3-63