MAINTENANCE Every 1000 Hours Maintenance Maintenance for every 100, 250 and 500 hours service should be carried out at the same time. Replace Hydraulic Oil Filter Element • The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. • When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. Remark If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations. For details, See “Maintenance Interval for Hydraulic Breaker” on page 3-20 when carrying out maintenance. 1.
Set the work equipment on the hard and flat ground in the maintenance posture as shown in the figure, then lower it to the ground and stop the engine. 2. Remove the cap from oil filler (F), and release the internal pressure. 3. Loosen 6 bolts, then remove cover (1). When doing this, the cover may fly out under the force of spring (2), so hold the cover down when removing the bolts. 4. After removing spring (2), valve (3) and strainer (4), take out element (5). Inspect the bottom of the filter case for dirt, and remove it, if any. Take good care not to let dirt fall into the hydraulic tank. 5. Clean the removed parts in diesel oil. 6.
Install the new element in the place where old element (5) was installed. 7. Set valve (3), strainer (4) and spring (2) on top of the element. 8. Set cover (1) in position, push it down by hand, and install the cover with the mounting bolts. 9. Screw in the oil filler cap and install the cover. 10. To bleed the air, start the engine according to “STARTING ENGINE” on page 2-134 and run the engine at low idle for ten minutes. 11. Stop the engine. 3-72 PC200LC-8