Komatsu — Change Oil in Swing Machinery Case

MAINTENANCE Change Oil in Swing Machinery Case Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. Refill capacity PC200: 7.1 liters (1.88 US gal) 1. Remove cover (A) of the inspection hole. 2. Set a container under drain valve (P) under the machine body to catch the oil. 3. Loosen drain valve (P) under the body, drain the oil, then tighten the drain valve again. Remark • If the oil forms thin threads, there is no problem in stopping the draining operation.

• In low temperatures, swing the work equipment to raise the oil temperature slightly before starting the operation to drain the oil. However, never swing the work equipment during the draining operation. This will cause breakage of the swing machinery. 4. Remove the cap of oil filler (F), then add the replacement amount of oil through oil filler (F). 5. Pull out dipstick (G) and wipe off oil on the dipstick with cloth. 6. Fully insert dipstick (G) into filler pipe (F), then remove it. 7. The oil level should be between H and L marks on the dipstick (G). If the oil does not reach the L mark, add oil through oil filler port (F). PC200LC-8 3-73