OPTIONS, ATTACHMENTS Lock Pin Use this lock pin (4) to lock the control pedal. Position (a): . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .LOCK Position (b): . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Only front of pedal can be operated fully (rear of pedal is locked) Position (c): . . Both front and rear of pedal can be operated fully When not using the attachment, keep lock pin (4) at position (a). When using the breaker, use the working mode selector switch on the monitor switch portion to set the working mode to B mode, and set the lock pin to position (b) when using the pedal.
When using the crusher, use the working mode selector switch on the monitor switch portion to set the working mode to ATT mode, and set the lock pin to position (c) when using the pedal. Remark • When using the breaker, if the lock pin is set to position (c) and the pedal is operated in direction (D), it will cause damage or defective operation of the breaker. To prevent this, when using the breaker, always set the lock pin to position (b). • Before changing the position of the lock pin, set lock lever to the LOCK position (L) and turn the key in the starting switch to OFF position (A).
Breaker Circuit Additional Oil Filter This filter (5) prevents deterioration of the hydraulic oil when using a breaker. Oil only flows when B mode is selected on the monitor. Attachment-ready machines are equipped with additional filter (5) as standard when they are shipped from the factory. Remark Always install an additional filter in the return circuit on machines equipped with a hydraulic breaker. 5-6 PC200LC-8