OPTIONS, ATTACHMENTS ATTACHMENT REMOVAL AND INSTALLATION Attachment Removal 1. Lower the attachment to the ground and stop the engine. 2. Turn the starting switch to the ON position (B), then set the lock lever to the FREE position (F). 3. To release the pressure inside the hydraulic circuit, operate each work equipment control lever and attachment control pedal slowly to the front, rear, left, and right fully two or three times. 4. Set the lock lever to LOCK position (L). 5. Loosen slowly oil filler cap (F) on top of the hydraulic tank to eliminate the internal pressure in the hydraulic circuit. PC200LC-8 5-17