OPTIONS, ATTACHMENTS Precautions when using: Check that the stop valve is at the FREE position. Check that the working mode is B mode. For details of the path of the oil, see “HYDRAULIC CIRCUIT” on page 5-8. When considering whether it is necessary to install an accumulator for the attachment circuit, contact the attachment manufacturer and then decide. For other precautions when handling the breaker, follow the instruction manual from the breaker manufacturer and use the breaker correctly. The deterioration of the hydraulic oil when using the breaker is much faster than for normal operations, so reduce the maintenance interval for the hydraulic oil and element.
For details, see “Maintenance Interval for Hydraulic Breaker” on page 3-20. When Using General Attachment such as Crusher With the working mode set to ATT mode, insert the lock pin in front-and- rear FREE position (c). Press the front or rear of the pedal to operate the attachment. If the working mode pilot monitor does not display ATT for the attachment mode, press working mode selector switch (1) and set to the attachment mode as follows. If P, E, or L mode are selected, the attachment is not actuated. PC200LC-8 5-23