MISCELLANEOUS 0 Thoroughly wash the machine, particularly the oiling and greasing parts and the vicinity, thereof, in order to prevent the ingress of dust. l Use genuine Komatsu replacement parts specified in the parts list. l Use Komatsu specified oil and grease. Use oil and grease having the recommended viscosity for the particular ambient temperature. 0 Use clean oil and grease and keep them in clean containers to avoid the ingress of dust. l Drain off used oil after heating it to a suitable temperature (about 20 to 40°C). l Inspect or replace oil in a dust-free location to prevent the ingress of dirt. l After replacing oil, filter element or strainer, bleed the air from the circuit.
0 When the strainer is located in the oil filler, the strainer must not be removed while adding oil. 0 When adding oil or checking the oil level, check that the oil is at the cor- rect level. l After greasing up, always wipe off the old grease that was forced out. l When changing the oil or filter, check the drained oil and filter for any signs of excessive metal particles or other foreign materials. l When removing. parts containing O-rings, gaskets or seals, clean the mounting surface and replace with new sealing parts. l When washing the machine, ensure that water does not get onto the alternator. l Special measuring apparatus is needed for testing hydraulic pressure.
0 Thoroughly wash the machine. In particular, be careful to clean the filler caps, grease fittings and the area around the dipsticks. Be careful not to let any dirt or dust into the system. 0 When check an open cover there is a risk of dropping things in. Before removing the covers to inspect cover, empty everything from your pock- ets. Be particularly careful to remove wrenches and nuts. 0 When working on the sea shore, check that the various plugs and valves, etc., are tightened up properly. After the completion of work, thoroughly wash the machine and carefully clean all electrical equipment to ensure that is does not corrode.
l Before working in muddy water, rain or snow, check that the various plugs, valves, are properly screwed up. Upon completion of work, wash the machine, then check the various parts of the machine for cracking, scratching, loose or missing nuts and bolts. Also, oil and grease the var- ious parts of the machine. l When working on rocky ground, be careful of damage to the undercarri- age, loose nuts and bolts, cracks, wear and other damage. Also, adjust the track tension so that it is a little slacker than usual. - 50 -