l When installing car radio and a walkie-talkie or citizen band, contact your Komatsu distributor. l Do not direct the steam jet directly at any mechatronic parts or connec- tors. l Do not get any water on the controllers or monitors inside the operator’s cab. l Do not direct a high-pressure jet directly at the radiator. 0 After disconnecting the connector, cover it with a vinyl bag to prevent oil or dust from sticking to its contact section. l When welding, be careful of the following: 1) Turn OFF the power (starting switch). 2) Do not continuously apply more than 200 V. 3) Install the ground cable at least 1 m from the range to be welded.
4) Do not insert any seal or bearing between the weld and ground. 5) When repairing the controller mount, remove the controller connectors and carry out the welding. Precautions when power source for options When installing electrical components such as a car cooler, connect to the special power source connector. The power source for options must never be connected to the fuse, start- ing switch, or battery relay. -51 -