SECTION 5 MAINTENANCE Page 18 BELTS 5.7.1. Visual Inspection Fig. 5.4. Belt Inspection Replace badly worn, greasy or cracked belts immediately. These conditions prevent proper belt function. Visually inspect the drive belts for intersecting cracks. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace a belt if it is frayed or has pieces of material missing. 5.7.2. CHECKING TENSION AND ADJUSTMENT 5.7.2.1. Checking tension and adjustment of fan belt The engine is equipped with an automatic belt tensioner that maintains correct tension on the drive belt.
The tension should be 360-490 [N]. To check belt tension a Borroughs type gauge must be used. If the gauge is unavailable, check the tension by pressing the belt with the thumb on the longest portion of the belt. The deflection should be 9.5-13 [mm]. Check the fan belt tension every 1000 hours of operation. Fig. 5.5. Belt Tension Check 1. Crankshaft Pulley. 3. Idler Pulley 2. Fan Pulley 4. Alternator Pulley 5. Water Pump Pulley TD-15H DRESSTA