MAINTENANCE SECTION 5 Page 23 COOLING SYSTEM 5.8.7. REFILLING AN OVERHEATED SYSTEM WARNING! Hot, scalding coolant can spray out if the radiator cap is removed suddenly. Relieve system pressure by slowly turning the cap to the first notch or lifting the safety lever. Remove the cap only after the pressure has been relieved. WARNING! Use extreme caution when adding coolant to a hot radiator to avoid being burned. Wear gloves and goggles and keep your face away from the filler neck. Never add coolant when the engine is hot. This may result in damage to the engine. Allow the engine to cool down below 50[°C] prior to replenishing the coolant in the radiator. 5.8.8.CHANGING COOLANT 5.8.8.1.
Draining the System 1. Position the machine on the level ground. Run the engine until it reaches operating temperature then stop the engine. Fig. 5.9 Radiator Drain Valves. 1. Radiator Drain Valve 2. Drain Valve on Engine Block 2. Remove the radiator cap. 3. Open the radiator drain valve and the main drain valve located on the engine block and drain the system completely (Fig. 5.9). 5.8.8.2. Filling the Drained System IMPORTANT: Do not fill a cooling system with water alone. Use antifreeze and water solution in proportions as specified in chart 5.3.1. according to the ambient temperature. 1. Close the radiator drain valve and the valve on the engine body (Fig.5.9). DRESSTA TD-15H