SECTION 5 MAINTENANCE Page 24 COOLING SYSTEM 2. Fill the cooling system slowly. This allows more air to escape and the system to be filled to its maximum capacity. Fill the system until the coolant fills completely the sight gauge (Fig. 5.8), approximately 43 [mm] above the inner baffle in the radiator top tank. 3. Install the radiator cap. Start the engine and run until the normal operating temperature is reached. Check for leaks and add coolant to the proper level. 5.9. FAN AND FAN HUB Fig. 5.10. Fan WARNING! Keep clear of fan and fan belts when engine is running. Rotating fan and belt contact can cause injury. 1.
Check the condition of the fan blades (cracks, damaged, rivets, loose mounting bolts) and bearing of the idler pulley. 2. Reversible fan blades (if equipped) should be reversed periodically to clean the radiator and engine compartment. After reversing the blades adjust them in the required position. 5.10. ELECTRIC SYSTEM 5.10.1. ELECTRIC WIRES AND CONNECTIONS WARNING! Before working on an engine or electric system, turn off the electric system master switch and remove the key. All terminals must be clean and fastened securely. Replace frayed, cracked, and poorly insulated wiring. Electric system shall not be tampered with. Wrongly made alterations may cause machine damage or fire.
The surface under all terminals must be clean, and good electrical connections must be established after any reassembly. Also, all clips must grip cables tightly to prevent vibrations and rapid cable wear. All clips and straps must be closed in a workmanlike manner, so as not to damage the insulation. TD-15H DRESSTA