SECTION 5 MAINTENANCE Page 26 ELECTRIC SYSTEM Maintenance Proper battery maintenance will assure maximum service. Following are a few simple rules: Keep battery cable terminals clean and tight. Keep the filler cap vent holes unplugged. Replace worn, cracked, broken or corroded cables. Keep the battery fastened securely in frame. IMPORTANT: Excessive tightening can warp or crack a battery case. Maintain the correct battery electrolyte level. Refer to "Electrolyte Level" below. Always charge the battery in a ventilated area. Keep the battery clean. Refer to "Cleaning the Batteries" below. CUATION! The following precautions must be taken when working around batteries:
Use a battery carrier to avoid spilling electrolyte on clothing. Wearing rubber aprons and gloves is advisable. Be careful that tools or other metallic objects do not fall across the battery terminals. Never break a live circuit at the terminals. This could cause sparks. Make sure charger cable clamps or booster leads are clean and making good contact. If it becomes necessary to prepare electrolyte of a desired specific gravity, always pour acid into water. Always turn the charger to the OFF position before connecting or removing charger leads to a battery.
Be sure the electric system master switch is off when connecting or disconnecting a battery to minimize the chance of sparks and explosion. Cleaning the Batteries If the top of a battery is dirty, it may be cleaned with a brush dipped in ammonia or soda solution and then rinsed with water. Electrolyte Level The electrolyte in each cell must be at the proper level (21 to 27 [mm] above the plates) at all times to prevent battery failure. Check periodically the level of electrolyte. When the electrolyte is below this level, pure distilled water must be added. Never use hydrant water or any water which has been in a metal container.
A skilled battery man must never add except acid or electrolyte. Under no circumstances add any special battery solutions or powders. It is especially important to keep a battery at full charge for cold weather operation. Add distilled water to the battery in freezing temperatures only when the engine is to operate for several hours, to thoroughly mix the water and the electrolyte, or damage to the battery may occur. Battery Charge When a machine is not in use for an extended period, the maintenance-free battery can become discharged. For this reason, when a machine will not be used for over 30 days, it is recommended that the negative ground terminal cable be disconnected.
Prior to starting up a machine that has been idle, always make a visual inspection of the battery and take the open circuit voltage test. A reading of 12.4 volts (75% of full charge) or less indicates a state of discharge and the battery should be charged. Check amount of charge of batteries: 100% of full charge 1.26 – 1.28 [g/cm 3 ] 75% of full charge 1.23 – 1.25 [g/cm 3 ] 50% of full charge 1.20 – 1.22 [g/cm 3 ] Fully discharged 1.11 – 1.13 [g/cm 3 ] TD-15H DRESSTA