DRESSTA Co. Ltd. TD-15H — 5.11.2. CHANGING THE CRANKCASE OIL AND OIL FILTER

MAINTENANCE SECTION 5 Page 27 5.11. ENGINE 5.11.1. CHECKING THE CRANKCASE OIL Fig. 5.12. Oil Level Gauge WARNING! Park the machine on level ground, stop the engine, lower all mounted equipment to the ground, lock the transmission shift the lever in neutral, apply the brake pedal lock, turn off the electric system master switch. Stop the engine and check the oil level. For an accurate reading wait for the oil to drain into the crankcase pan. Open the side access door. Remove the oil level gauge and wipe it clean. Reinsert the gauge completely. Remove the gauge and check the oil level.

If the level is at or below the MIN (ADD) mark, add oil through the fast fill receiver to bring the level up to the MAX (FULL) mark on the gauge. Refer to "REFILL SPECIFICATIONS AND CAPACITIES CHART" for type and viscosity of oil specified. Reinstall the level gauge. IMPORTANT: Never run an engine, if the level of the oil is at or below the MIN (ADD) mark on the oil level gauge. 5.11.2. CHANGING THE CRANKCASE OIL AND OIL FILTER Change the engine oil and oil filter every 250 hours. CAUTION! Hot parts – wear gloves. Fire hazards – do not smoke. WARNING!

Whenever working under the machine, turn off the electric system master switch, remove the key and tag the controls to prevent inadvertent starting. DRESSTA TD-15H