MAINTENANCE SECTION 5 Page 39 HYDRAULIC SYSTEM Fig. 5.30. Hydraulic Return Filter 5.13.4. SERVICING THE SUCTION STRAINER Fig. 5.31.Hydraulic Oil Suction Strainer (Inside Hydraulic Reservoir) and Filler Strainer 1. Filler Strainer 2. Suction Strainer 3. Nut 4. Washer 1. Park the machine on level ground, lower the blade to the ground and stop the engine. Turn the electric master switch OFF. With the engine stopped, operate the equipment lever several times to relieve any pressure. Drain the hydraulic system. Refer to "CHANGING HYDRAULIC OIL". 2. Remove three bolts and remove the cover of the hydraulic reservoir. Remove nut (3). Remove strainer (2) from the reservoir. 3.
Remove the snap ring securing filler strainer (1). Clean and dry the strainer and install it in the reservoir cover. 4. Clean the suction strainer in nonflammable commercial solvent and dry thoroughly. Thoroughly clean the interior of the reservoir being sure all particles are removed from the corners. DRESSTA TD-15H