DRESSTA Co. Ltd. TD-15H — 5.14. LUBRICATING FITTINGS

SECTION 5 MAINTENANCE Page 42 LUBRICATING FITTINGS Fig. 5.34. Hand and Foot Control Linkage Lubrication Fittings Mounted equipment fittings: Gimbal crosstube (2 fittings), Ripper pins (10 fittings), Lubricate the ripper pins every 50 hours of operation in average conditions. The lubrication period should be shorter in extremely heavy conditions. Always use clean lubricators and containers. Apply fresh grease until the old lubricant and dirt is removed. Fig. 5.35. Mounted Equipment Fittings Apply grease until clean lubricant is visible. Always use a clean lubricator and wipe dirt from fittings before fresh grease is applied.

If grease fails to go through the fitting, determine the cause and correct it. Gimbal cross tube and yokes: Remove the plugs and apply grease until clean lubricant is visible from breathers. TD-15H DRESSTA