DRESSTA Co. Ltd. TD-15H — 5.20. ADJUSTING HAND AND FOOT CONTROLS

MAINTENANCE SECTION 5 Page 61 UNDERCARRIAGE 5.19.10. FRONT WHEEL GUIDES Periodically check the thickness of the front wheel guides. (4 pieces in the right track frame and 4 in the left track frame). If they are worn (min. thickness is 16 [mm]) replace them. 1. Minimum Guide Thickness 16 [mm]. 2. Guide Clearance Fig. 5.58. Front Wheel Guide Clearance 5.20. ADJUSTING HAND AND FOOT CONTROLS Check the engine high and deceleration RPM. If RPM values are incorrect proceed as follows: Check the adjustment of the hand levers and foot pedals as described below (Fig. 5.59): a) Adjust lever (4) to vertical position of the lever for high idle speed (2400 ± 100 [RPM]).

During the adjustment lever (1) must be placed in its foremost position. b) Adjust lever (2) to maintain the dimension 200 [mm] and 36 [mm]. c) Adjust foot pedal (3) to maintain the dimensions in [mm] I - Engine high speed position (2400 ± 100 [RPM]) II - End of deceleration (11000 ± 100 [RPM]) III - Beginning of braking IV - Full braking DRESSTA TD-15H