Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - INSPECTION AND CORRECTION 2.7 Extracting the camshaft bushing (1) Remove the camshaft bushing using the special tool Camshaft Bushing Installer in the following manner. (2) Remove the oil pan. (3) Using the punching side of the installer, punch the bushing off and into the cylinder block. Take it out of the block by slightly deforming it. 2.8 Press-fitting the camshaft bushing Press-fit the bushing while ensuring that the oil holes of the bushing align with the oil galleries in the cylinder block. 2.9 Measuring the camshaft cam height Measure the camshaft cam height as illustrated. If the measured value is less than the limit, replace the camshaft. Unit:

mm (in.) Cylinder block front face Camshaft bushing Camshaft bushing installer Extracting the camshaft bushing 1 mm (0.04 in.) Notch on the bushing 1 mm (0.04 in.) Oil hole Mating mark Press-fitting the camshaft bushing Measuring location Measuring direction 2.10 Measuring the fuel injection pump shaft cam height Measure the cam height as illustrated. If the measured value is less than the limit, replace the fuel injection pump shaft. Unit:

mm (in.) Measuring the camshaft cam height Measuring location Measuring direction Measuring the fuel injection pump shaft cam height 2 - 25 Special tool Part number Camshaft Bushing Installer ST332340 Standard value Limit Camshaft cam height (including lobe) 35.720±0.1 (1.4073±0.0039) 34.720 (1.3679) Standard value Limit Fuel injection pump shaft cam height (including lobe) 44±0.1 (1.736±0.0039) 43 (1.6942)