ENGINE MAIN PARTS - REASSEMBLY 2. Flywheel, Timing Gear, Camshaft To reassembly, follows the disassembly sequence in reverse. 2.1 Installing the front plate (1) Completely scrape off any remaining gasket from the cylinder block and the front plate. (2) Install the front plate onto the cylinder block. Tighten the four retaining bolts. (3) Apply sealant onto the side of the gasket that is to be mated to the front plate. Attach the gasket onto the front plate. The sealant will prevent the gasket from moving. 2.2 Installing the oil pump (1) Ensure that the oil pump is correctly fitted with packing. (2) Install the oil pump onto the crankcase. Tighten the three retaining bolts evenly.
(3) Ensure that the oil pump gear rotates smoothly. 2.3 Rotating the engine (1) Install two studs (M12 Ч 1.25) into the flywheel mounting holes in the crankshaft. (2) Place a bar between the studs and rotate the crankshaft until the No. 1 cylinder comes to the top dead center. 2.4 Tapping the fuel injection pump camshaft into place (1) Insert the fuel injection pump camshaft (complete with the bearing and the gear) into the cylinder block. (2) Tap the gear with a plastic hammer until the bearing is completely inserted into the mounting hole in the cylinder block. (3) Ensure that the fuel injection pump camshaft rotates smoothly. (4) Tighten the stopper bolt.
Front plate retaining bolts Installing the oil pump Rotating the engine Tapping the fuel injection pump camshaft into place 2 - 40