ENGINE MAIN PARTS - REASSEMBLY 2.5 Installing the camshaft (1) Apply engine oil to the journals and cams. (2) Insert the camshaft (complete with the camshaft gear) into the cylinder block. Take care not to damage the journals or cams when inserting the camshaft into the cylinder block. Apply engine oil Installing the camshaft (3) Using an appropriate torque wrench and socket, tighten the thrust plate mounting bolts to the specified torque. (4) Ensure that the camshaft rotates smoothly. Also ensure that there is some end play by sliding the camshaft to the front and rear. 2.6 Installing the idler gear (1) Apply engine oil to the idler shaft.
(2) Install the idler gear so that the timing marks are aligned with those of the meshing gears. (3) Check the backlash between the gears. Note: Refer to “Measuring the timing gear backlash” on Page 2-23. 2.7 Installing the timing gear case (1) Apply sealant onto the gasket and stick it in place. Then, install the timing gear case onto the front plate. (2) Apply engine oil to the oil seal lips. (3) Tighten the timing gear case retaining bolts. Tightening torque: 9.8 to 11.8 N m (1.0 to 1.2 kgf m) [7.2 to 8.7 lbf ft] Installing the thrust plate Aligning the timing marks Installing the timing gear case 2 - 41