Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - REASSEMBLY 2.8 Tightening the crankshaft pulley nut (1) Use the studs and the bar described in Section “2.3” to lock the crankshaft. (2) While locking the crankshaft, tighten the crankshaft pulley nut to the specified torque. Tightening torque: 147 to 196 N m (15.0 to 20.0 kgf m) [108.5 to 144.7 lbf ft] The locking studs and bar should be sufficiently strong to avoid any accident. Tightening the crankshaft pulley nut 2.9 Installing the PTO gear Drive the PTO gear into the timing gear case. Ensure that the side of the gear with no oil hole faces the rear of the engine.

2.10 Inserting the tappets Apply engine oil to the periphery of the tappets, and insert them into the tappet holes in the cylinder block. 2.11 Installing the oil seal case (1) Install a new oil seal case gasket. (2) Apply engine oil to the entire periphery of the oil seal lips, and install the oil seal and case onto the cylinder block. Driving the PTO gear into place Apply engine oil Inserting the tappet Installing the oil seal case 2 - 42