Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - REASSEMBLY 2.12 Installing the rear plate (1) Install a new rear plate gasket. (2) Install the rear plate, aligning it with the dowel pins. Tighten the retaining bolts to the specified torque. Note: Install the rear plate complete with the starter. This will facilitate the subsequent reassembly. 2.13 Installing the flywheel housing Install the flywheel housing, aligning it with the knock pins. Tighten the retaining bolts evenly. Note: Replace the knock pins with new parts if the knock pins are worn or if a new flywheel housing is being installed.

2.14 Installing the flywheel (1) Screw in a safety stud (M12 Ч 1.25) into one of the flywheel retaining bolt holes at the rear end of the crankshaft. (2) Insert the flywheel through the safety stud and onto the crankshaft. (3) Loosely tighten the three flywheel retaining bolts. (4) Replace the safety stud with the 4th retaining bolt, and loosely tighten it. (5) Using a torque wrench or other similar tool, lock the crankshaft pulley nut. (6) Tighten the flywheel retaining bolts to the specified torque. Tightening torque: 53.9 to 73.5 N m (5.5 to 7.5 kgf m) [39.8 to 54.2 lbf ft] Installing the rear plate Installing the flywheel housing Safety stud Installing the flywheel Tightening torque:

127 to 137 N m (13.0 to 14.0 kgf m) [94.0 to 101.3 lbf ft] The person who locks the crankshaft pulley nut should do so with extreme care. Communicate with each other closely to prevent accidents. Tightening the flywheel bolts 2 - 43