ENGINE MAIN PARTS - REASSEMBLY 3. Cylinder Head, Valve Mechanism To reassembly, follows the disassembly sequence in reverse. 3.1 Cleaning the bottom face of the cylinder head Scrape off any gasket from the mating faces of the cylinder head and the cylinder block, taking care not to damage the faces. Note: Use a scraper to roughly remove the remaining gasket. Then, using an oil stone and engine oil, polish away fine residue. 3.2 Installing the valve stem seals Using a box wrench No. 12, install the valve stem seal on the valve guide. Ensure that the seal has been correctly installed the valve guide. Note:
Incorrectly installed stem seals will lead to oil leaking down through the seal-to-guide gap and into the combustion chamber. 3.3 Installing the valve springs Install the valve spring with the white enamel-coated end facing up. 3.4 Installing the valve locks Install the valve lock by compressing the valve spring using a valve lifter. Removing the old gasket Box wrench No. 12 Inserting the valve stem seal White enamel coating Installing the valve springs Do not compress the valve spring too hard as the bottom of the retainer may contact and damage the stem seal. Installing the valve lock 2 - 44