ENGINE MAIN PARTS - REASSEMBLY 3.5 Installing the cylinder head gasket (1) Ensure that the cylinder block top face and the piston top faces are clean. (2) Insert two guide studs (M10 Ч 1.25) into the bolt holes in the cylinder block. (3) Install the cylinder head gasket through the studs and onto the cylinder block. Guide stud Do not use liquid packing or other similar sealant. Installing the cylinder head gasket 3.6 Installing the cylinder head Install the cylinder head through the guide studs and onto the cylinder block. 3.7 Tightening the cylinder head bolts (1) Remove the guide studs. Install the cylinder head bolts.
(2) Tighten the cylinder head bolts in the order illustrated in a couple of steps, and finally tighten to the specified torque. 3.8 Inserting the push rods (1) Insert the push rods into the holes in the cylinder head. (2) Ensure that the ball end of the push rod rests on the recess of the tappet. Guide stud Installing the cylinder head 5 10 4 2 7 S4L,S4L2 8 13 11 12 14 1 9 6 3 Front of engine Tightening torque: 83.4 to 93.2 N m (8.5 to 9.5 kgf m) [61.5 to 68.7 lbf ft] 8 2 4 7 9 6 3 5 10 11 1 S3L,S3L2 Tightening order for the cylinder head bolts Inserting the push rod 2 - 45