ELECTRICAL EQUIPMENT -0.6 remove the link from between the terminals and restore the orig inal connections. STARTER MOTORS General The following information is concerned with the M45G starter motor. Two types of drive are available and both are covered fully in the following section. Should in- formation be required in connection with any other type of starter motor then the relevant manufacturer should be contacted. BRUSH STARTER MOTORS Run-off Helix Drive (See Fig. 0.4) 1. Description-Model M45G Type RF 17 This electric starter motor is a four-pole four-brush machine having an extended shaft which carries the engagement gear, or starter drive as it is more generally known.
The starter motor is of a similar construction to the dynamo except that heavier copper wire is used in the construction of the armature and field coils. The field coils are series-parallel connected between the field terminal and the insulated pair of brushes. The armature has 23 winding slots. The drive portion incorporates a special overload protective device known as the Run-off Helix. 05 gently on the flexible connectors (Refer to Fig. 0.5). If movement is sluggish, remove the brush from its holder and clean its sides with a fluffless petrol moistened cloth. Replace the brush in its original position. Brushes which are worn to less than 9/16 in (14 mm) long must be renewed. NOTE:
This is the length when half the available wearing length has worn away. The time taken to reach this stage normally extends well beyond that to reach the point of major engine overhaul. After this time, the rate of wear accelerates due to re- ducing spring pressure. 2. Routine Maintenance (a) The starter motor requires no routine maintenance beyond the occasional inspection of the electrical connection which must be clean and tight, the brush gear, and the commutator. (b) After the starter motor has been in service for some time remove the starter motor from the engine and submit it to a thorough bench in- spection. 2. Check the tension of the brush springs using a spring scale.
(Refer to Fig. 0.6). The minimum tension is 43 ozf (0,61 kgf). New springs should be fitted if the tension is low. 1. Check that the brushes move freely in their holders by holding back the brush springs and pulling MODEL M45G TYPE RF 17 BRUSHES COMMUTATOR END COVER BAND COVER BAND BRACKET NUT FIELD COILS DRIVE END BRACKET BEARING BUSH ....... , .. j I THRUST WASHERS SEARING BUSH ~ PINION & SLEEVE MAIN SPRING SHAFT NUT 04 FIXED SLEEVE PINION RESTRAINING SPRING