DD PLATFORM APPLICATION AND INSTALLATION MANUAL 1. O-ring 10. Shift Mechanism (Totally Enclosed) 2. End Cap (Removal for Inspection) 11. Two-piece Housing 3. Bronze Bearing 12. O-ring 4. Connector Strap 13. Bronze Bearing 5. Gasket 14. Heavy-duty Drive Overrunning Clutch 6. Low Friction Bushing 15. Bronze Bearing 7. Seamless, One-piece Solenoid Case 16. O-ring 8. O-ring 17. Shaft Seal 9. Sealing Boot 18. One-piece Brush Figure 11-6 Typical Cranking Motor Cross-section Excessive engine cranking may cause the starter to overheat and may reduce its life. Cranking time should not exceed 30 seconds, with a two minute cool down interval between cranking periods.
11.2.3 ALTERNATORS The battery-charging alternator provides a source of electrical current for maintaining the storage battery in a charged condition. The alternator also supplies sufficient current to carry any other electrical load requirements up to the rated capacity of the alternator. All information subject to change without notice. 11-9 DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION