ELECTRICAL SYSTEM 11.2.3.1 Alternator Mounting The typical mounting assembly includes a mounting bracket that matches the alternator mounting lugs, an adjusting strap, and associated hardware. The following guidelines are provided for correct alternator mounting: NOTICE: Do not mount the alternator near the exhaust manifold. Mounting near the exhaust manifold could overheat the alternator and the regulator. A mounting location close to the engine block minimizes mounting bracket overhang. A mounting location not subject to resonant vibration is best.
The alternator mounting assembly should support the alternator rigidly so that the alternator pulley grooves are in the same plane as the driving pulley grooves on the engine. Provision must be made for belt tension adjustment. Drive and driven pulleys must be in parallel and angular alignment to prevent short belt life or loss of belt. Anchor the adjusting strap and mounting brackets to a rigidly fixed heavy section. Motion between the mounting bracket and adjusting strap can create an unacceptable vibration. Incorrect mounting can result in: Improper alignment of pulleys Excessive vibration of mounting assembly components Improper alignment of pulleys causes excessive belt or pulley wear.
Society of Automotive Engineers' (SAE) recommended practice should be followed with respect to pulley alignment and tolerances. The pulley groove must be concentric with the bore and the pulley should be adequately balanced. Fabricated sheet metal pulleys are not recommended for applications with heavy belt loads. Belt resonance will result in short belt life. Contact the belt manufacturer if belt resonance is a problem. Excessive vibration of mounting assembly components can cause failure of the mounting bracket, the adjusting strap, the alternator mounting lugs, or other alternator components. An effective bracket must stay firmly attached to the engine.
Under special circumstances, an OEM or distributor may require the mounting location of an alternator not supplied by DDC. Prior to the manufacturing of the mounting components, the OEM or distributor must supply details of the design for review. Also a vibration test will be required. Contact Application Engineering for details. 11-10 All information subject to change without notice. DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION