DD PLATFORM APPLICATION AND INSTALLATION MANUAL Figure 12-1 General Three Point Mounting Scheme NOTE: The engine must be analyzed for the bending moment produced at the rear face of the block. If the bending moment exceeds the limit of 1,356 N·m (1,000 ft·lb), then the rear mounts must be located to achieve a bending moment within these limits, ideally as close to zero as possible. The rear mounts should restrain motion in all six degrees of freedom and provide the necessary torque reaction forces. Isolation mounts can be used under both front and rear mounting brackets if applicable.
12.2 SOLID MOUNTING SYSTEMS Solid mounting is used in applications where severely high shock, torque and/or thrust loads are introduced. Solid mounts are, therefore, used in instances where flexible mounting is not acceptable due to the physical conditions which will be encountered for the given application. In any solid mounting arrangement, consider the following : Make the mounting brackets and mounting base as rigid as possible. Alignment of the engine and the machine being driven must be carefully controlled to minimize loading on the coupling, flywheel, and flywheel housing. If the assembly is remote mounted and shaft driven with a coupling, check for face run out to 0.002 in.
(0.051 mm) on each flange apart. With flanges together a 0.127 mm. (0.005 in) gap is permitted for angular misalignment. Concentricity, also checked with dial indicators, should be good within 0.127 mm. (0.005 in). (Make adjustments by shimming under one or more of the solid mounts. All information subject to change without notice. 12-3 DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION